Dip Switch Tables - Epson TM-T88IV Manual Del Usuario

English

DIP Switch Tables

Serial Interface (DIP switch 1)
SW Function
1-1 Data receive error
1-2 Receive buffer
capacity
1-3 Handshaking
1-4 Data word length
1-5 Parity check
1-6 Parity selection
1-7 Transmission speed (See table below.)
1-8
Transmission speed
Transmission speed (bps)-bits per second
38400 *1
4800
9600
19200
Serial Interface (DIP switch 2)
SW Function
2-1 Handshaking
(BUSY condition)
2-2 Do not change
2-3 Print density/
2-4 Low power
2-5 Release condition
of receive buffer
BUSY (If receive
buffer capacity
set to 4 KB.)
2-6 Do not change
2-7 I/F pin 6 reset
2-8 I/F pin 25 reset
*1. Only when DIP Switches 1-7 and 1-8 are on, the
transmission speed can be selected from one of
seven speeds: 2400, 4800, 9600, 19200, 38400, 57600,
and 15200 bps. The default is 38400.
iv
ON OFF
Ignored Prints "?"
45 bytes 4K bytes
XON/XOFF DTR/DSR
7 bits 8 bits
Enabled Disabled
Even Odd
1-7
ON
OFF
ON
OFF
ON OFF
Receive buffer Offline or
full Receive buffer
full
See Table A
Releases BUSY Releases BUSY
when remaining when remaining
receive buffer receive buffer
capacity capacity
reaches reaches
138 bytes. 256 bytes.
Enabled Disabled
Enabled Disabled
Parallel Interface (DIP switch 1)
SW Function
1-1 Auto line feed
1-2 Receive buffer
capacity
1-3 Select paper
sensors to output
paper-end
signals (default
value of ESC C 3)
1-4 Error signal output
1-5~ Undefined
1-8
1-8
Parallel Interface (DIP switch 2)
ON
SW Function
ON
2-1 Handshaking
OFF
(BUSY condition)
OFF
2-2 Do not change
2-3 Print density/
2-4 Low power
2-5 Release condition
of receive buffer
BUSY (If receive
buffer capacity
set to 4 KB.)
2-6 Do not change
2-7
2-8 I/F pin 31 reset (Do not change)
Table A
Print density/low power
– Low power consumption mode
Print density "Normal"
Print density "Medium"
Print density "Dark"
ON OFF
Always Always disabled
enabled
45 bytes 4K bytes
Disabled Roll Paper end
sensor enabled,
Roll Paper near-
end sensor
enabled
Disabled Enabled
ON OFF
Receive buffer Offline or
full Receive buffer
full
See Table A
Releases BUSY Releases BUSY
when remaining when remaining
receive buffer receive buffer
capacity capacity
reaches reaches
138 bytes. 256 bytes.
SW 2-3 SW 2-4
ON ON
OFF OFF
ON OFF
OFF ON