DeWalt DW744 Manual De Instrucciones página 5

FIG. 3
SCREW-DOWN
HOLES
GAUGE
FIG. 4
WORK SUPPORT
EXTENSION
(RETRACTED)
MOUNTING
BLADE GUARD
ON-OFF SWITCH
RIP SCALE INDICATOR
RAIL LOCK
LEVER
FINE ADJUST
KNOB
BLADE HEIGHT
ADJUSTMENT
WHEEL
BEVEL LOCK
LEVER
ANTI-KICKBACK TEETH
RIP FENCE
LATCH
Specifications
Horsepower 2-1/2
Table Size 19 1/4" x 26 1/2"
Miter Angle 30 ° L&R
Bevel Angle 0° to 45°L
Blade Size 10" (254mm)
Max. Cut Depth 0° Bevel ................ 3 1/8" (79ram)
Max. Cut Depth 45 ° Bevel .............. 2-1/4" (57mm)
RPM, no load 3650
Unpacking
Open the box and slide the saw out, as shown in Figure 1.
Carefully unpack the table saw and all loose items from the
carton. Examine all parts to make sure that parts have not
been damaged during shipping. If any parts are missing or
damaged, contact your dealer to replace them before
attempting to assemble the tool.
Figure 2 shows all the loose items and hardware packed with
the saw.
1. Rip fence
2. Blade (attached to saw base)
3. Arbor wrench and spindle wrench (attached to saw
base)
4. Blade guard
5. Throat plate
6. Miter gauge
Examine Figures 3 & 4 to become familiar with the saw and
its various parts. The following sections on assembly and
adjustments will refer to these terms and you must know
what and where the parts are.
Assembly
YOUR SAW SHOULD BE ASSEMBLED IN THE
FOLLOWING ORDER:
1. Blade
2. Rip fence (NOTE: Adjust rip scale before proceeding.
See "Adjusting Rip Scale".)
3. Blade guard
4. Throat plate
FIG. 5
PIN
OPENING
BLADE/WRENCH
STORAGE
DUST EXHAUST