Tools And Parts; Installation Requirements; Parts Supplied - Kenmore 191.57754412 Instrucciones De Instalación

Tools and Parts

Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed for all installations:
Flat-head screwdriver
Level
Plastic putty knife
Tin snips (new vent
installations)
#2 Phillips screwdriver
4

INSTALLATION REQUIREMENTS

Adjustable wrench that
opens to 1" (25 mm) or
hex-head socket wrench
Vent clamps
Caulking gun and compound
(for installing new exhaust
vent)
1/4" (6 mm) and
5/16" (8 mm) nut driver
(recommended)
Wire stripper (direct wire
installations)
Tape measure
Tools needed for gas installations:
8" (203 mm) or 10"
(254 mm) pipe wrench
Pipe-joint compound
resistant to propane gas

Parts supplied:

Leveling legs (4)
Parts package is located in dryer drum. Check that all parts
are included.
If using a power supply cord:
Use a UL Listed power supply cord kit marked for use
with clothes dryers. The kit should contain:
A UL Listed 30-amp power supply cord, rated 120-/240-volt
■
minimum, and have a temperature rating of 140ºF (60ºC)
minimum. The cord should be type SRD or SRDT and be
at least 4 ft. (1.22 m) long. The wires that connect to
the dryer must end in ring terminals or spade terminals
with upturned ends.
A UL Listed strain relief.
■
Pliers
8" (203 mm) or 10"
(254 mm) adjustable wrench
(for gas connections)