Caring For Your Stylistic Lt P; Protecting The Display Screen - Fujitsu Stylistic LT P-600 Manual Del Usuario

Caring for Your Stylistic LT P-600

This chapter gives you pointers on how to care for and maintain your Stylistic LT P-600 pen tablet.

Protecting the Display Screen

The Stylistic LT P-600 pen tablet is designed to provide you with years of service. Using a screen
protector will help ensure that the screen remains as clear as possible. When installed, the screen
protector becomes a durable, replaceable writing surface that protects the display screen from
abrasion.
To obtain additional screen protectors use Fujitsu part number FMWSP11 (12-pack) when ordering.
(These and other accessories can be ordered from the FPC web site at www.fujitsupc.com.) Additional
information about installation is included with the screen protectors.
C A U T I O N
During normal use of the pen tablet, small particles from the
environment can become embedded in the pen tip and scratch the
screen. To prevent scratching the screen, ensure that a screen protector
is installed before using your pen tablet. The warranty does not cover a
screen that is scratched as a result of not using a screen protector.
To install a new screen protector on your pen tablet:
1. If a screen protector is already installed on the display screen, remove it before installing the new
screen protector.
The screen protector is held onto the display screen surface by a thin strip of adhesive around the
edges. A notch in one corner of the screen protector allows you to slide your fingernail under the
screen protector for easy removal.
2. Clean the display by wiping the screen surface gently using a soft cotton cloth dampened with
denatured alcohol. Ensure that all residue has been removed from the screen before applying a
new screen protector. Remove the protective coating from the adhesive side of the screen
protector first.
C A U T I O N
The Stylistic LT P-600 pen tablet is not waterproof. Do not pour liquids
on the system or wash it with a heavily soaked cloth.
3. Apply the screen protector to the display screen surface. When doing so, orient the screen
protector with the adhesive side of the screen protector facing the display screen and the notched
corner of the screen protector toward the lower left corner of the display screen.
4. Apply pressure to the screen protector with your finger using a continuous wiping motion along
the edges. The adhesive sets completely within 48 hours. To ensure a good seal between the
screen protector and the display, do not lift the screen protector from the display once it has been
applied.
C a r e a n d M a i n t e n a n c e
1
31