Pen Tablet Is Not Responding To The Pen; Audio Volume Too Low; Configuring Peripherals Interfaces - Fujitsu Stylistic LT P-600 Manual Del Usuario

S t y l i s t i c L T P - 6 0 0 P e n T a b l e t - C h a p t e r F o u r
• The distance between the two devices must not be more than approximately 3 feet or 1 meter.
• The viewing angle from the IrDA port on the pen tablet must not be more than 15 degrees from a
center line between the IrDA port on the pen tablet and the IrDA port on the other device.
• The device with which you are trying to communicate must be compliant with the IrDA
Standard Revision 1.1 (or 1.0).

Pen Tablet Is Not Responding to the Pen

If your pen tablet is not responding to the pen, connect an external keyboard to the system to see if it
responds to keyboard commands. If the system doesn't respond to the keyboard, the application or
system may have crashed, and it may be necessary to reset the system.

Audio Volume Too Low

If the audio volume on your pen tablet speaker or external headphones is too low, check the
following:
• Ensure that the speaker (or headphone output if using headphones) is enabled. To do so, tap the
Speaker Mute hotpad. The system beeps when the speaker or headphone output is turned on
using the hotpad.
• Ensure that the volume level set with the Volume hotpads is set to an audible level.
• Ensure that the mute box in the system volume control (accessible from the system tray) is not
set.
• Ensure that any volume control in your audio software is set to an audible level.

Configuring Peripherals Interfaces

Certain peripheral devices can be disabled during the BIOS Setup. If the peripheral interface you
want to use does not appear to be working with your peripheral device, ensure that it is enabled in
the BIOS. Contact your local help desk or reseller if you need assistance using BIOS Setup.
34
1
1
1