Fujitsu Stylistic LT P-600 Manual Del Usuario página 58

S t y l i s t i c L T P - 6 0 0 P e n T a b l e t - A p p e n d i x C
communications. However, there is no guarantee that interference will not occur in a particular
installation. If the equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet that is on a different circuit than the receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Shielded interconnect cables must be employed with this equipment to ensure compliance with the
pertinent RF emissions limits governing this device.
C A U T I O N S
When using your modem equipment, basic safety precautions should
always be followed to reduce the risk of fire, electric shock, and injury to
persons, including the following:
• Do not use this product near water (for example, near a bath tub, wash
bowl, kitchen sink or laundry tub, in a wet basement or near a
swimming pool.
• Avoid using a modem during an electrical storm. There may be a
remote risk of electric shock from lightning.
• Do not use the modem to report a gas leak while in the vicinity of the
leak.
Notice to Users of the US Telephone Network
The Stylistic LT P-600 pen tablet is supplied with an internal modem which complies with Part 68 of
the FCC rules. On the pen tablet is a label that contains the FCC Registration Number and Ringer
Equivalence Number (REN) of this system, along with other information. If requested, users must
provide their telephone company with the following information:
• The telephone number to which the pen tablet is connected
• The Ringer Equivalence Number (REN) for this equipment
• The information that the system requires a standard modular jack type USOC RJ-11C which is
FCC Part 68-compliant
• The FCC Registration Number
This equipment is designed to be connected to the telephone network or premises wiring using a
standard modular jack type USOC RJ-11C which is FCC Part 68-compliant.
48
1