Workzone AJ54 Manual Del Usuario página 17

1/4 Sheet Sander · 2.0 AMP Operation
turning the switch off.
Contact the work piece with minimal pressure. If the sander is not removing enough material,
try a heavier grit piece of sandpaper.
Note:
•To minimize sanding marks, keep the sander moving slowly while it is touching the work piece.
•Occasionally stop the sander and check the sandpaper for tears, wear, or fraying. If necessary,
replace the sandpaper.
•Empty the dust bag regularly in order to ensure the optimum removal of dust by suction.
•From time to time, clean the dust exhaust opening with a dry brush.
•Clean the housing only with a damp cloth, do not use any solvents!
•To prevent accidents, turn off the tool and unplug it after use. Clean, then store the tool indoors
and out of children's reach.
AFTER-SALES SUPPORT 14
1855 399 9415
support@sumec-na.com