Tabla de contenido
Publicidad
Preparation
Getting Started
It's a good idea to read all of the instructions before beginning the installation.
Tools and Supplies
The following tools and supplies are needed to install the radio.
•
Torx type, flat-head and Philips screwdrivers
•
Wire cutters and strippers
•
Tools to remove existing radio (screwdriver, socket wrench set or other tools)
•
Electrical tape
•
Crimping tool
•
Volt meter/test light
•
Crimp connections
•
18 gauge wire for power connections
•
16–18 gauge speaker wire
NOTE: Only connect speakers rated in the load impedance of 4 ohms. Speakers with a
load impedance less than 4 ohms could damage the unit.
Disconnect Battery
Before you begin, always disconnect the battery negative terminal.
Remove Radio from Sleeve
Lift latches on both sides of sleeve to remove half-sleeve from radio.
Install Half-Sleeve
1. Install adapter and dash kit if necessary (optional).
2. Install half-sleeve into adapter or dashboard.
3. Push tabs out to secure half-sleeve in the radio opening.
4. Install support strap to stabilize unit.
Remove Radio from Sleeve
Remueva el Radio de la Manga
Enlever la radio du manchon
MP 86
10 BT
Install Half-Sleeve
Instalación de la Camisa
Installation du demi-manchon
3
2
6
WA TT
S
P
T M
Connect Wires
Conecte los cables
Raccordement des fils
4
1
MP8610BT
Jensen Connector
1
2
Publicidad
Tabla de contenido
