Wiring
Wiring with a Wiring Adapter (Purchased Separately)
Connect Wires
You can make all these connections without even being in the car.
1. Splice or crimp wires.
2. Attach wiring adapter to car wiring harness.
Wiring Diagram / Color Codes
1. Power Antenna (dark blue wire) – Connect to power antenna or amplifier. If not used, tape
bare end of wire.
2. Ground (black wire) – Connect to ground terminal or clean, unpainted part of chassis.
3. Memory/Battery (yellow wire) – Connect to battery or 12 volt power source that is always
alive. The radio will not work if this wire is not connected.
4. Accessory/Ignition (red wire) – Connect to existing radio wire or radio fuse.
5. Left Front Speaker
6. Right Front Speaker
7. Left Rear Spearker
8. Right Rear Speaker
9. RCA Outputs to Amplifier
10. Auxiliary Input Cable (yellow)
11. Antenna
12. CD Changer
13. Subwoofer Output
Fuses
When replacing a fuse, make sure the new fuse is the correct type and amperage. Using an
incorrect fuse could damage radio. The MP8610BT uses one 15 ampfast blow ATO fuse
located below the wiring connector.
Reconnect Battery
When wiring is complete, reconnect the battery negative terminal.
FUSE
FUSIBLE
FUSIBLE
12
REAR/POSTERIOR/ARRIÈRE
GREY/GRIS/GRIS
BLACK/NEGRO/NOIR
FRONT/FRENT/AVANTE
White/Black (-)
Gray/Black (-)
Blanco/Negro (-)
Gris / Negro (-)
Blanc/Noir (-)
Gris / Noir (-)
5
White / Blanco / Blanc (+)
Gray / Gris / Gris (+)
Green/Black (-)
Violet/Black (-)
Verde/Negro (-)
Violeta/Negro (-)
Vert/Noir (-)
Violet/Noir (-)
7
Violet / Violeta / Violet (+)
Green / Verde / Vert (+)
8
Wiring / Cableado / Câblage
WHITE/BLANCO/BLANC
YELLOW/AMARILLO/JAUNE
10
RED/ROJO/ROUGE
RCA-TO-RCA CABLES
(not supplied)
BLUE/AZUL/BLEU
WHITE/BLANCO/BLANC
RCA-TO-RCA CABLES
WHITE
BLANCO
(not supplied)
BLANC
RED
ROJO
ROUGE
WHITE
BLANCO
BLANC
RED
ROJO
ROUGE
BLUE/AZUL/BLEU
1
BLACK/BEGRO/NOIR
2
YELLOW/AMARILLO/JAUNE
3
RED/ROJO/ROUGE
4
20-PIN AUDIO/POWER HARNESS
1
2
3
4
5
11
12
13
14
15
6
Pin View
8
MP8610BT
11
13
9
AMP
6
7
8
9
10
16
17
18
19
20