Battery Change; Function Keys - TFA Dostmann 30.3006 Manual De Instrucciones

stop this process and the display will show the temperature for the first
transmitter. The process also stops automatically if no keys are pressed for a
few minutes.
6. Once the remote temperature has been received and is displayed on the
Temperature Station, the DCF-77 time code reception is automatically
started. This takes typically between 3-5 minutes in good conditions. This
time period is an excellent opportunity to locate the transmitter(s) in suitable
location(s) outdoors. In order to ensure sufficient 433 MHz transmission
however, this should under good conditions be no more than 20 - 25 meters
from where the Temperature Station will be finally positioned (see notes on
"Positioning" and "433 MHz Reception check").
7. If after 10 minutes, the DCF time has not been received, use the SET key to
manually enter a time initially. The clock will automatically attempt each hour
to receive the DCF time. When this is successful, the received time will
override the manually set time. The date is also updated with the received
time. (Please refer also to notes on "Radio controlled Time Reception" and
"Manual Time Setting").
HOW TO INSTALL AND REPLACE BATTERIES IN THE
TEMPERATURE STATION
The Temperature Station uses 2 x AA, IEC, LR6,
1.5V batteries. When batteries will need to be
replaced, the battery symbol will appear on the
LCD. To install and replace the batteries, please
follow the steps below:
1. Insert finger or other solid object in the space
at the bottom centre of the battery
compartment and lift up to remove the cover.
2. Insert batteries observing the correct polarity
(see marking).
3. Replace compartment cover.
HOW TO INSTALL AND REPLACE BATTERIES IN THE
TEMPERATURE TRANSMITTER
The Temperature transmitter uses 2 x AAA, IEC,
LR3, 1.5V batteries. When batteries will need to
be replaced, the battery symbol will appear on
the LCD.
To install and replace the batteries, please follow
the steps below:
1. Unscrew the screw on the back of the compartment and remove the cover.
2. Insert the batteries, observing the correct polarity (see marking).
3. Replace the battery cover on the unit and seal by re-screwing.
Note:
In the event of changing batteries in any of the units, all units need to be reset by
following the setting-up procedures. This is because a random security code is
assigned by the transmitter at start-up and this code must be received and stored
by the Temperature station in the first 3 minutes of power being supplied to it.

BATTERY CHANGE:

It is recommended to replace the batteries in all units on an annual basis to ensure
optimum accuracy of these units.
Please participate in the preservation of the environment. Return
used batteries to an authorized depot.

FUNCTION KEYS:

Temperature Station:
The temperature station has eight easy to use function keys, 4 on the outside and
four behind a shutter inside the lower compartment:
Indoor
Outdoor
Setting
Alarm 1
Alarm 2 Date
SET key (Setting)
•
Used to enter the set mode for the following functions: Time, Time zone,
Year, Date and Weekday
•
The year can also be displayed in the set mode (not displayed in normal
mode)
•
Used to activate the snooze function for the alarm
IN key (Indoor)
•
Used to toggle between the current/ maximum/ minimum indoor temperature
and humidity
•
Press for over 3 seconds to reset the indoor maximum and minimum
temperature and humidity records (will reset all records to current level)
•
Changes the hour, time zone, year, day and weekday setting when in set
mode
Channel
Snooze