Dometic WAECO Perfect Power Serie Instrucciones De Montaje página 34

Fastening and connecting the inverter
Connecting the inverter to the 230 V mains supply
➤ Plug the 230 V connection cable into the connector for the 230 V power
supply to the inverter (fig. 1 2, page 3).
➤ Connect the 230 V connection cable to a 230 V socket in the vehicle.
Connecting the remote control to the inverter
➤ Switch off the inverter.
➤ Insert the cable end of the remote control into the connection (fig. 2 2,
page 3).
➤ Set the main switch (fig. 2 1, page 3) to "Remote".
Connecting the external switch contact to the inverter
➤ Switch off the inverter.
➤ Connect the external switch contact (power supply from the inverter) at
the remote port (fig. 2 3, page 3) in accordance with the wiring diagram
(fig. 3, page 3),
➤ Set the main switch (fig. 2 1, page 3) to "Remote".
NOTE
I
If you wish to use an external switch contact with a power supply of
it own, e.g. the ignition, you must interconnect a suitable relay.
8.3 Connecting multiple consumers
WARNING! Danger of electrocution!
!
If you wish to connect more than one consumer to the inverter and
install a socket distribution circuit, you must arrange a circuit break-
er (residual current circuit breaker) and set a grounding bridge in
the inverter. The grounding bridge may only be connected by a
trained professional who is familiar with the relevant VDE (German
Engineering Society) regulations.
The device is equipped at delivery with galvanic isolation. For the safe
operation of multiple consumers, it is essential that a circuit breaker (residual
current circuit breaker) is built into the socket distribution circuit, see sample
circuit diagram in fig. 6, page 5.
34
PerfectPower
EN