Using The Inverter - Dometic WAECO Perfect Power Serie Instrucciones De Montaje

Using the inverter

9 Using the inverter
NOTICE!
A
If no circuit breaker is present: If the inverter is connected to the
external mains voltage, the 230 V output socket is earthed.
If there is no external mains voltage, the inverter is only connected
to the battery (DC operation). In this case, the 230 V output socket
is not earthed, but safeguarded with the protective insulation in-
stead.
NOTICE! Risk of short circuit!
A
You must switch on the inverter first before switching on the con-
sumers.
When using the inverter, observe the following instructions:
 If the battery voltage drops below the alarm value during operation (see
"Low voltage alarm" in "Technical data" on page 40), a warning signal
sounds and LED "UVP" (fig. 1 7, page 3) lights up.
 If the battery voltage drops below the shutdown value (See "Low voltage
shutdown" in "Technical data" on page 40), the inverter switches off.
 If the inverter overheats, it switches off and LED "OLP" (fig. 1 6, page 3)
lights up.
After it cools down, the inverter automatically switches back on.
 When operating the inverter at a high load for lengthy periods, it is
advisable to start the engine in order to recharge the vehicle battery.
➤ Connect your consumer to the 230 V output (fig. 1 4, page 3).
You can also connect a socket distribution system.
36
PerfectPower
EN