Urrea SK904 Manual De Usuario página 14

corte 30º corte 0º
STRAIGHT CUT
When using the jigsaw
to perform straight
cuts, remember
attach the cover,
plastic guide and the
plastic sawfoot cover.
The use of the plastic
guide will prevent the
sawblade from swing-
ing during the cut.
ANGLE CUT
SETTING THE CUTTING ANGLE
The preset angle between the saw foot and
saw blade is 90°. You can adjust this angle on
both sides gradually to 15°/30°/45° using angle
scale as reference.
• Use the large hex key to set the sawing angle.
Loosen the tightening screw with the hex key
far enough so that the saw foot can be easily
turned.
• For straight cuts the angle scale should be
set to 0°. For angle cuts set the scale to value
between 1° and 45°.
• Set the saw foot to the desired position
15°/30°/45° on the angle scale. After the angle
14
corte 45º corte 15º
to
is set push the saw foot down until is locked in
place. Retighten the tightening screw with the
large allen key.
DIP SAWING
Only 50ft working materials, such as wood or
plaster cardboard, may be used for dip sawing!
For dip sawing, only use short saw blades and
always set the sawing angle to 0°.
• Place the peak of the saw blade and the front
parts of the saw foot on the workpiece.
• Switch the jigsaw on and allow the saw blade
to run.
• Slowly reduce the angle of support ofthe
sawfoot i n the direction of the workpiece. The
saw blade "dips" into the area to be cut out.
At this time, the power tool may not be moved
sideways.
• As soon as the saw foot lies smoothly on the
workpiece, you can begin sawing.
SAWING OUT AREAS
• With a drill, drill a sufficiently large hole in-
side of the area to be sawed out.
• Guide the saw blade into this hole and be-
gin to saw out the desired area. Use the la ser
guide to obtain more precise cuts.
MOUNTING THE PARALLEL GUIDE
The parallel lines can be sawed with miter-
precise intervals using a parallel guide.
Parallel cuts are only available when the angle
of the saw foot is set to 0° and the plastic cover
for saw foot is removed.
• Using screwdriver loasen the tightening
screw of the parallel guide.
• Push the parallel guide into the guideway
opening. The parallel guide can be inserted in
the left or right side of the power tool.
• Align the guide rail and retighten the tight-
ening screw.