130 Series Heatsink And Mounting; Dimensions - DART Controls 130 CONTROL SERIES Manual De Instrucciones

·
CUR LIM (Current Limit) - Provides protection from excessive armature current by limiting the
maximum armature current the control can provide. This enables adjustment of the maximum torque
the motor can deliver. Torque adjustment (Cur Lim) is preset at 125% of rated motor torque (current)
based on horsepower. Clockwise rotation of the "CUR LIM" trimpot increases the torque (current)
the control will provide.
·
BARRIER TERMINAL BLOCKS - Allows for connection of AC lines, motor leads, motor field (if
needed), speed potentiometer and Fwd-Brake-Rev inputs.
·
ONBOARD DYNAMIC BRAKE RESISTOR - Consult factory for available remote mounting option
of Brake resistor.
·
POWER LOSS BRAKE - Upon a power loss to the control or an E-stop command, the control will
drop into a dynamic brake condition to safely and quickly bring the motor to a stop and remain there
until power is reapplied and a run condition is recognized.

130 SERIES HEATSINK AND MOUNTING

AUXILIARY HEATSINK -HS(125D)
0.688
5.625
4.020
1.375

DIMENSIONS

0.218
5.625
6.250
STANDARD HEATSINK
0.694
7.000
0.188 DIA.
(8 SLOTS)
2.645
1.295
0.250
3
5.227
5.077
3.628
1.750 0.750
11/32
SLOT
DEPTH
(8 SLOTS)
3.750
4.250
0.385