Mounting Dimensions; 65E10 Mounting; Installation; Hook-Up Diagrams - DART Controls CONTROL Serie Manual Del Usuario

.188" DIA.
(6 SLOTS)
11/32"
SLOT
DEPT
Caution: Do not mount controller where ambient temperature is outside the range of -10° C (15° F) to 45° (115° F).
Before attempting to wire the control, make sure all power is disconnected. Recheck code designation to assure proper
voltage is present for the control. Caution should be used in selecting proper size of hook-up wire for current and voltage
drop.
DO NOT REVERSE POSITIVE AND NEGATIVE BATTERY LEADS. THIS WILL DAMAGE THE CONTROL.
TO CHANGE MOTOR DIRECTION, INTERCHANGE THE POSITIVE AND NEGATIVE ARMATURE LEADS.
Refer to the wiring diagrams below for proper connection of DC Voltage, Armature, and Speedpot wiring to the control.
CAUTION !! TURN POWER OFF WHILE MAKING CONNECTIONS.
To properly adjust the CURRENT LIMIT setting, a DC ammeter should be placed in series with the armature line. This meter
can be removed after the control is adjusted.

MOUNTING DIMENSIONS

65E10 MOUNTING

MIN
MAX
ACCEL
IR COMP
CUR LIM
.315"
SIDE VIEW

INSTALLATION

HOOK-UP DIAGRAMS

4.250"
TOP VIEW
3.750"
WARNING:
2
P1
.694"
-9
-8
-7
-6
1.750"
-5
3.625"
-4
-3
-2
-1
1.300"
.380"