TECshow ET DUAL Manual De Usuario página 4

3. MOUNTING
When installing the unit, the trussing or area of
installation must be able to hold 10 times the
weight without any deformation. When installing
the unit must be secured with a secondary safety
attachment, e.g. and appropriate safety cable. Nev-
er stand directly below the unit when mounting,
removing, or servicing the unit.
Overhead mounting requires extensive experience,
including calculating working load limits, instal-
lation material being used, and periodic safety
inspection of all installation material and unit. If
you lack these qualifications, do not attempt the
installation yourself.
The installation should be checked by a skilled
person once a year.
The fixture is fully operational in three different
mounting positions, hanging upside-down from
a ceiling, set on a flat level surface, or on its side
attached to trussing. Be sure this fixture is kept
4. DMX SET UP
Notice: Be sure to follow figures two and three
when making your own cables. Do not use the
ground lug on the XLR connector. Do not connect
the cable's shield conductor to the ground lug or
allow the shield conductor to come in contact with
the XLR's outer casing. Grounding the shield could
cause a short circuit and erratic behavior.
P. 4
Tecshow ET Dual | English version
at least 0.5m away from any flammable materials
(decoration etc.). Always use and install the sup-
plied safety cable as a safety measure to prevent
accidental damage and/or injury in the event the
clamp fails.
Notice: The suitable environmental temperature for
this lighting fixture is between -25˚ C to 45˚ C. Do not
place this lighting fixture in an environment where
the temperatures are under or above the tempera-
tures stated above. This will allow the fixture to run
at its best and help prolong the fixture life.
Screw one clamp via a M12 screw and nut to the in-
cluded bracket. Attach the bracket using the includ-
ed screws to the bottom of the fixture. Attach the
eyehole screw to the bottom of the base and pull
the safety-cable through the screw and over the
trussing system or a safe fixation spot. Insert the
end in the carabine and tighten the safety screw.
XLR Pin Configuration
Pin 1: Ground
Pin 2: Data Compliment (negative)
Pin 3: Data True (positive)