Closing The Door; Replacing The Lamp; Installation - Electrolux FI22/12 Manual De Instrucciones

Problem
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.

7.2 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.

8. INSTALLATION

8.1 Location
Refer to the assembly
instructions for the
installation.
To ensure best performance, install the
appliance well away from sources of heat
such as radiators, boilers, direct sunlight
etc. Make sure that air can circulate
freely around the back of the cabinet.
8.2 Positioning
Install the appliance in a dry, well
ventilated indoors where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance.
Possible cause
Many food products are
stored at the same time.
The thickness of the frost
is greater than 4-5 mm.
The door has been opened
often.
The FastFreeze function is
switched on.
There is no cold air circula‐
tion in the appliance.

7.3 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
3. If necessary, replace the defective
Climate
class
SN
N
ST
T
Solution
Store less food products at
the same time.
Defrost the appliance.
Open the door only if nec‐
essary.
Refer to "FastFreeze func‐
tion".
Make sure that there is
cold air circulation in the
appliance.
to assembly instructions.
door gaskets. Contact the Authorised
Service Centre.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
ENGLISH 13