Bissell PROHEAT 2X PREMIER 47A2 Serie Guia Del Usuario página 16

Possible causes Remedies
Water tank may be empty Fill heavy duty bladder with hot
tap water
d
Tank may not be seated Turn aower OFF. Remove and
or completel reseat tank
Pump may have lost prime. Turn power OFF and then back ON.
Wait one minute then depress trigger
The belt is off or broken Turn power OFF and unplug unit
from outlet. Follow instructions on
page 15
Circuit breaker on machine may Turn the machine OFF and unplug
have tripped from outlet. Check to see if foreign
object is caught in brush roll.
Remove object. Plug machine in to
reset circuit breaker
Tank may not be seated properly Pick up the 2-in-] water tank and
re-seat it so it sits snugly on the unit.
Cleaner
not picking
up solution
Tank may not be assembled
properly
-in-1 water tank is empty
2-in-1 water tank has picked up
maximum dirty water and red
float door has closed.
Red float "door" in the tank may
have closed as a result of bumping
object or moving machine back
and forth too quickly
Make sure the tank latches on both
sides of the tank are latched properly.
To make sure they are both latched
Check fluid levels in heavy-duty
bladder.
Empty 2-inq water tank. Refill heavy
duty bladder with clean hot tap water
and replace.
........................................................................................................................................................... I
Turn the machine OFF, allowing red
float door to release an into the open
position. Turn unit back ON to
continue cleaning. Be sure your
forward and backward strokes are
done at a slower pace.
Red lint screen near air duct Follow cleaning instructions in
is dirty Step 4 on Page 13.
....... _i_iiiii,!i_:,,