Bissell PROHEAT 2X PREMIER 47A2 Serie Guia Del Usuario página 15

Brush removal and brush belt replacement
Brushes can be removed for cleaning or
replacement as needed.
1. Follow drive belt removal Instructions on
page 14.
2. Remove brush rolls by pulling them off of
the metal rods. Be careful not to lose the small
washer at each end of the brush rolls.
3. Replace the brush belt if necessary.
4. Place cleaned or new brush rolls back onto
the rods. Make sure one washer is on each end
of the rollers prior to sliding onto the rod. Be
sure to let the rod slide through the bushing to
insure proper fit.
5. Re-attach the brush belt on the bottom
to the cogs of the small roller brushes.
6. Replace the drive belt by following step 8
on page 14.
7. Place pivot arm in place and screw in place
using the silver screw.
8. Replace nozzle by lining up the locking keys
with their slots and placing the nozzle back onto
the foot of the machine. Secure into place by
turning the locking keys to the "lock" position.
If you have any questions or are having trouble
installing or replacing your belt(s) or brushes,
please call BISSELL Consumer Care.
2,
7.
www.BISSELL._