Cleanin_l
with
the Stain Trapper
tool (select
models)
Your deep cleaner may have come with a
Stain Trapper
tool. This tool is great for keeping
messes out of the machine's
hose system.
1, Attach
the Stain Trapper
tool to the end
of the hose.
2. Gently
scrape up any semi-solids
with a spoon
or spatula.
Do not use a knife or other utensil
with sharp edges because
it could damage
the
carpet
or upholstery.
3, Follow instructions
3-6 on page 9 under
"Cleaning
with attachments".
NOTE: Do not fill the Stain Trapper tank
above the FULL line.
4. To empty
the Stain Trapper
tool, rotate
the small tank on the bottom
of the tool
to unlock
it.
4.
NOTE:
Be careful
to keep
the top
of the tool
facing
upward
or soiled
water
will
spill out
of
the tank.
5. Dump dirty water into a sink or toilet and
rinse the tank out with clean water. Replace
the tank by lining up the "unlock"
symbol
with
the small arrow on the tank and turning
it to
the "lock"
symbol.
6, Clean the front of the tool by removing
the
plate over the suction
path. Pull down on the
bottom
of the plate to remove. Run the tool
and the plate under clean water to rinse taking
care to remove all debris. Replace the front
plate by sliding it back into place.
Clean-up
1, Remove the tank from the base of the machine
by lifting
up on the tank carry handle. Carry like
a bucket
to a utility
sink or outside
where you
will dispose
of the dirty water.
2, Unlatch the top of the tank from the bottom
by lifting
up on the tank latches on either side
of the tank.
3. Remove the top of the tank by lifting
up on
the handle.
2.
4. Lift the bottom
portion
of the tank; pour out
dirty water
in the sink through
the rectangular
shaped opening
in the corner
of the tank.
NOTE: You may notice hair & debris deposits
on the carpet or in the tank that were loosened
by the cleaning
action. This debris should be
picked up and thrown away. Check the red lint
filter near the duct on the back of the machine
base for debris and remove before continuing.
3.
Filter
www.BISSELL.com
_"
800.237.7691
10