Switching Unit Of Weight (Unit); Restoring Factory Settings (Reset) - Seca 676 Manual De Usuario

Switching unit of weight
Restoring factory
settings (RESET)
80 •
3. Select a filtering level.
– 0: no filtering
– 1: moderate filtering
– 2: high filtering
4. Confirm your selection.
You exit the menu automatically.
On non-calibrated scales, you can select the unit (Unit)
(Unit) in which you want weight to be displayed.
CAUTION!
Patient hazard
In order to avoid misinterpretations, test results
for medical use must be displayed and used in
SI units only. Some devices offer the ability to
display test results in other units. This is only an
additional function.
– Use the results exclusively in SI units.
– The use of measurement results in non-SI
1. Select the item "Unit" from the menu.
2. Confirm your selection.
The current setting is displayed.
Select the unit in which you want weight to be
displayed:
– kilograms (kg)
– pounds (lbs)
– stones (sts)
3. Confirm your selection.
You exit the menu automatically.
You can restore the factory settings for the functions
below.
Auto hold (Ahold")
Beep (Press)
Beep (Hold)
Filtering (Fil)
Autoclear (Aclear)
Pre-tare (Pt)
Height for Body Mass Index
(BMI)
units is the sole responsibility of the user.
Function Factory setting
Model-dependent
Off
On
0
Model-dependent
0 kg
170 cm