Original Operating Manual 1 Symbols; Safety Instructions; Emission Levels - Festool VN-HK 85 130x16-25 Manual De Instrucciones

Original operating manual
1 Symbols................................................ 9
2 Safety instructions ............................... 9
3 Intended use......................................... 10
4 Technical data ...................................... 10
5 Machine features ................................. 10
6 Assembly .............................................. 10
7 Settings ................................................ 11
8 Working with the electric power tool... 11
9 Service and maintenance..................... 12
10 Environment......................................... 12
The specified illustrations appear at the beginning
of the Operating Instructions.
1 Symbols
Symbol Significance
Warning of general danger
Read operating instructions and safety
notices!
Wear protective gloves.
Wear protective goggles.
Wear a dust mask.
Disconnect from the power supply!
Tip or advice
Handling instruction
Tool for manual guidance
MAN
Carbide-tipped cutters, tungsten carbide
HW
2

Safety instructions

2.1 General safety instructions
WARNING!
structions, illustrations and specifications
provided with this power tool. Failure to follow all
instructions listed below may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future ref-
erence.
The term "power tool" in the warnings refers to
your mains-operated (corded) power tool or bat-
tery-operated (cordless) power tool.
Read all safety warnings, in-
2.2 Machine-related safety instructions
- Always read the operating manual and follow the
safety instructions provided with the portable cir-
cular saw HK 85.
- Do not exceed the maximum speed stated on the
tool. If a speed range is given, the speed must be
kept within this.
- Always check whether the pendulum guard is
working correctly before using the machine. Do
not use the groove cutter if the protective cover
cannot move freely, is damaged or will not close
immediately.Do not clamp or otherwise tie the
pendulum guard to hold it open and never work
without the guards fitted.
- Only use original spare parts that have been de-
signed for the system.
- Do not use tools that have visible cracks in them.
(Reconditioning cutters with cracks is not per-
mitted.)
- The clamping surfaces must be clean and free of
lubricating grease, oil and water.
- Clamp the tools in such a way that they cannot
work loose during the machining process. Only
tighten the clamping screws using the tool de-
signed for this purpose.
- Never use dull or damaged mortising bits. Dull
or damaged mortising bits can cause the tool to
lurch sideways unexpectedly and lead to a loss of
control of the power tool.
- Do not install the groove unit or the adjustable
grooving cutter in any portable circular saw
other than the one specified. Installation in any
other portable circular saw may render the pow-
er tool unsafe to use and cause serious acci-
dents.
- Keep children and other persons away from the
power tool during use.
2.3

Emission levels

Levels determined in accordance with EN 60745 are
typically:
Sound pressure level
Sound power level
Uncertainty
Wear ear protection.
Vibration emission value a
directions) and uncertainty K measured in accor-
dance with EN 60745:
VN-HK85 130X16-25 GB
= 92 dB(A)
L
PA
= 103 dB(A)
L
WA
K = 3 dB
(vector sum for three
h
9