Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
ADJUSTING AIR PRESSURE
Do not exceed 120 psi (8.3 bar 8.5 kgf/
cm
2
).
Adjust the air pressure at recommended
operating pressure 70 – 120 psi (4.9 – 8.3 bar
2
5 – 8.5 kgf/cm
) according to the length of
staples and the hardness of workpiece.
The correct air pressure is the lowest
pressure which will do the job. Using the
Stapler at a higher than required air pressure
unnecessarily over stresses the Stapler.
LOADING STAPLES
When loading staples into Stapler,
1) do not pull trigger;
2) do not depress push lever; and
3) keep Stapler pointed downward.
(1) Pull the staple feeder backward and
attach it securely to a groove of the
magazine.
(2) Place the staple strip over the magazine.
Make sure that the staple strip slides
freely on the magazine.
WARNING
WARNING
Groove
Staple feeder
Staple
(3) Pull the staple feeder backward. Then,
detach it from the groove of magazine
and softly bring the staple back as if it
were being gently pushed, avoiding any
impact.
The Stapler is now ready to operate.
CAUTION
If the staple feeder is released all of a
sudden, it can return abruptly, causing
deformation and/or scatter, eventually
ending up in clogged staples.
Be absolutely sure to bring back the
staple feeder, avoiding any impact.
STAPLER OPERATION
Read section titled "SAFETY"(pages 5 – 8).
— 14 —
Magazine
Staple feeder
DANGER
Operators and
others in work
area MUST wear
safety glasses
with side shields
which conforms
to ANSI Z87.1
specifications.
Publicidad
Tabla de contenido
