Maintenance Maintenance And Inspection - Hitachi N 5024A2 Instrucciones Y Manual De Seguridad

English
NOTE:
The information contained in this Manual is designed to assist you in the safe
maintenance of the Stapler.
Some illustrations in this Manual may show details or attachments that differ
from those on your own Stapler.
MAINTENANCE AND
INSPECTION
Read section titled "SAFETY" (pages 5 – 8).
Disconnect air hose and remove all
staples from Stapler when:
1) doing maintenance and inspection;
and
2) clearing a jam.
1. Clearing a jam
Remove a jammed staple in the following
order:
1 DISCONNECT AIR HOSE.
2 Remove all staples.
3 Release the lock lever and open the
blade guide.
4 Remove the jammed staple with a
slotted-head screwdriver.
5 Close the blade guide and latch.
6 In case of frequent jam, contact a
Hitachi authorized service center.
Blade
guide
3
MAINTENANCE
WARNING
Lock lever
1
Disconnect
air hose
2. Storing
When not in use for an extended period,
apply a thin coat of the lubricant to the
steel parts to avoid rust.
Do not store the Stapler in a cold weather
environment.
Keep the Stapler in a warm area.
When not in use, the Stapler should be
stored in a warm and dry place.
Keep out of reach of children.
3. WARNING LABEL
Change the WARNING LABEL if missing
or damaged.
A new WARNING LABEL is available from
a Hitachi authorized service center.
Warning label
4. Maintenance chart (Page 20)
5. Operator troubleshooting (Page 20 – 21)
— 18 —
4