Laundrylux Cruce Serie Manual De Instalación página 14

2:2
Transportation Bolts
The washer is fitted with transportation bolts to prevent internal damage during
transportation. Transportation bolts must be removed before using the washer.
Removing Transportation Bolts
1. Unscrew the 4 bolts with a wrench. Remove the lower 2 bolts first, then the upper two.
Fig.
One of the bolts retains the power cord of the washer to prevent operating without
2
removing bolts.
2
2. Remove the bolts and the sleeves to release the power cord. Keep the 4 bolts
and sleeves for future use.
NOTE: If transportation bolts and sleeves are not removed, it may cause severe vibration,
noise and malfunction, as well as damage to the machine.
NOTE: When the washer is transported the transportation bolts and the sleeves must be
reinstalled
3. Close the 4 holes with the caps supplied.
Install the coin meter housing
1. Take out the coin meter housing from the base.
Fig.
3 2. Unscrew the 4 bolts provided on the coin vault,
put the coin meter housing on the vault, (a)
carefully feeding the two wiring harnesses into
the housing.
3. Install and tighten the 4 bolts securely.
4. Install the front plate of the coin meter and fasten
it.(b)
5. Install the coin meter.(c)
6. Plug the coin meter(s) into the Coin 1 (Red) and
Coin 2 (White) harnesses.
7. Install the cover of the coin meter housing.(d)
Installation
3
b
d
c
a