Ingersoll Rand 41-EU Serie Manual Del Usuario página 4

EN
Internal
1. Remove Clutch Housing and Clutch Assembly from tool.
NOTICE
Clutch housing has left-hand threads.
2. With bit in Bit Holder, clamp bit in vise.
3. Clamp drive end of Driven Jaw in leather-covered or copper-covered vise jaws being careful
not to damage Driven Jaw.
4. Hold Clutch Assembly from turning. Then rotate Adjustment Nut with 7/8" wrench.
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
Original instructions are in English. Other languages are a translation of the original instructions.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
EN-2 80167372_ed3