Medisana FTD Instrucciones De Manejo página 16

GB
2 Start-up
2.4
Setting
the time
2.5
Before you
start to use
the device...
16
Open the battery compartment by pressing the knob for opening the
battery compartment
battery compartment cover
until the hour display flashes. The hours are set by pressing the
9
On/Scan button
2
reached (see Fig.).
You can now switch from the hour setting to the minute setting by
pressing the time setting button again
es. Adjust the minute setting in the same way that you adjusted the
hour setting. When you have set the time, press the time setting but-
ton again as confirmation (see Fig.).
9
The display of the device now alternates between the time and
3
the ambient temperature (see Fig.).
• The thermometer is equipped with an encapsulated sensor
Special protection caps are not required.
• The sensor of the thermometer must be kept clean and intact
6
at all times in order to guarantee that the measurements are ac-
curate.
• Ear wax affects the measuring accuracy. If necessary, clean your ear
and the sensor tip of the thermometer before measuring in order
to avoid erroneous measurements.
• If the ambient temperature exceeds the designated range of 16 °C
to 40 °C when the ambient temperature is being measured, "Err"
will appear in the display
with a pointed object and removing the
8
. Press the button for setting the time
1
several times until the required hour setting is
9
.
3
. The minute display flash-
.
6