Miscellaneous - Medisana FTD Instrucciones De Manejo

6.
7.
8.
• The most important and sensitive part of the thermometer is
4.1
Care and
storage
• The sensor
• Normal commercial alcohol-based disinfectant is suitable for disin-
• The housing and the display
• Clean them with a dry, clean cloth. Do not use aggressive cleaners.
• It is advisable to keep the thermometer in the original packing that
• The storage temperature should be between -20.0°C to +50.0°C.
• The device is calibrated in the factory. Recalibration is not required
Dispose of your old electrical unit in an environmentally acceptable
4.2
manner when it has reached the end of its service life! Packaging is
Disposal
re-usable or may be recycled; metal parts must be disposed of as scrap
metal; plastics, electrical and electronic components must be disposed
of as electroscrap.
Remove the battery before disposing of the device. Do not throw
batteries away in the domestic rubbish: put them in the special wast
or a specialist dealer's battery collection station.
Consult your municipal authority or your dealer for information about
disposal.
3 Meas. procedure / 4 Miscellaneous
When temperature measurement is complete, you will hear a
beep and the body temperature will appear in the display
The device will then automatically go into time and ambient tem-
perature mode.
If the measured temperature is outside the permitted range, "Lo"
or Hi" will be displayed.
the sensor . Accurate temperature measurements can only be
6
guaranteed if the probe is clean and intact.
6 is waterproof and can therefore be cleaned by
directly immersing it in alcohol or using a ball of cotton wool
soaked in alcohol.
fecting the sensor
rer's instructions.
waterproof. Do not immerse them in liquids.
it was in when it was purchased, and keep it in a clean, dry place.
Do not expose the thermometer to direct sunlight.
for normal use.
. Please follow the respective manufactu-
6
of the thermometer are not
3
GB
.
3
19