Hilti PR 25 Manual De Instrucciones página 135

-CAUTION-
This equipment has been tested and found to comply
with the limits for a class B digital device, pursuant to
part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interfe-
rence in a residential installation. This equipment gene-
rates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio com-
munications.
However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment on and off, the user is encou-
raged to try to correct the interference by one or more
of the following measures:
Re-orient or re-locate the receiving antenna.
●
Increase the distance between the equipment and
●
receiver.
Connect the equipment to an outlet on a circuit diffe-
●
rent from that to which the receiver is connected.
Consult the dealer or an experienced TV/radio tech-
●
nician for assistance.
Changes or modifications not expressly approved by
Hilti could restrict the user's right to operate the equip-
ment.
Printed: 07.07.2013 | Doc-Nr: PUB / 5070173 / 000 / 00
This device complies with Part 15 of the FCC Rules and
RSS-210 of IC. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired ope-
ration.
Information plates on the product:
Made in Germany
Hilti= registered trademark of the Hilti Corporation, Schaan, Liechtenstein
LASER RADIATION - DO NOT
STARE INTO BEAM
This Laser Product
EN 60825-1:2003
620-690nm/0.95mW max.
complies with 21CFR
1040 as applicable
CLASS II LASER PRODUCT
Power: 4,5V=nom./150 mA
Made in Germany
Hilti= registered trademark of the Hilti Corporation, Schaan, Liechtenstein
LASER RADIATION - DO NOT STARE INTO
BEAM OR VIEW DIRECTLY WITH
OPTICAL INSTRUMENTS
620-690nm/2.45mW max.
CLASS IIIa LASER PRODUCT
Hilti Aktiengesellschaft
Matthias Gillner
Head BU Measuring Systems
01 / 2005
PR 25
1/4 s
2
PR 25 IF
3R
EN 60825-1:2003
This Laser Product
complies with 21CFR
1040 as applicable
Power: 4,5V=nom./150 mA
Dr. Heinz-Joachim Schneider
Executive Vice President
BA Electric Tools & Accessories
01 / 2005
ko
131