Installing On Windows Me - Epson IEEE 1394 I/F Manual De Instrucciones

9. Select Specify a location. If a different location is already selected,
deselect it, and click Next.
10. Make sure that D:\10000 (or 10000CF)\WIN2000 is displayed, then
click OK. (assuming your CD-ROM drive is D. If it is another drive,
use that drive letter instead.)
11. Check that the dialog box reads EPSON 1394 Printer IEEE 1394 SBP2
Device and then click Next.
Note:
If the system displays a message that the printer is not connected correctly,
do not click the Retry immediately. First click the Finish button, and then
the Retry button.
12. Wait for the message saying driver installation is complete, and click
Finish.
13. A message will be displayed saying that the printer driver and the
IEEE 1394 port settings are complete. Click OK.
14. When all settings are complete, the selected printer icon will be
displayed in the Printer folder.
After installation is complete, check if the driver has been installed
correctly. See "Ensuring that the IEEE 1394 driver is installed correctly
in Windows Me and 2000" on page 8 for more information.

Installing on Windows Me

1. Make sure that your printer is off and connected to your computer.
2. Turn on your computer and start Windows. If any applications are
running them, quit them.
3. Insert the printer software CD-ROM shipped with your printer in
the CD-ROM drive. The Installer dialog box appears.
If the dialog box does not appear, click Start and Run. Then, type
D:\SETUP and click OK. (assuming your CD-ROM drive is D. If it is
another drive, use that drive letter instead.)
7