Product Specifications; Unpacking - Delta 31-484 Manual De Instrucciones

Oscillation rate
Oscillation stroke
Spindle Speed
Motor
Table Size
Spindle Tilt
Spindle Size Range
Dust Chute
Base Dimensions
NET Weight
The machine is heavy, be careful when removing it from the shipping container! Failure to comply
may cause serious injury and/or damage to the tool and/or property!
This step requires two adults. The machine is heavy, be careful when removing it from the shipping
container! Failure to comply may cause serious injury and/or damage to the machine and/or
property!
Your DELTA ® Heavy Duty Oscillating Floor Spindle Sander comes packed in a single container. Use a safety strap to
avoid tip-over when lifting machine. Check shipping carton and machine for damage before unpacking.
1. Carefully cut the banding straps and remove them from the container.
2. Cut along the tape line at the top of the container.
3. Remove any loose parts accessible from the top of the container and set aside.
4. Cut vertically along each of the four sides of the container to fully expose the machine.
5. Remove any loose parts or hardware and set aside.
6. With the help of a second adult, carefully lift the machine off the pallet and onto a level floor surface.
7. Compare all parts to the list below and check that all parts are present and in good condition.
DESCRIPTION (QUANTITY)
• Floor spindle sander (1)
• Motor cover (1)
• Steel spindles and sanding
sleeves (4) (Diameter - 1/4",
3/8", 1/2", 5/8")
• Rubber spindles and sanding
sleeves (6) (Diameter - 3/4", 1",
1-1/2", 2", 3", 4")
• Oblong table inserts (3 (small,
medium, large)
Report any missing or damaged parts to your distributor or dealer. Prior to tool assembly and use, read this manual
thoroughly to familiarize yourself with proper assembly, maintenance and safety procedures.
Remove any protective materials and coatings from all of the parts and the sander. The protective coatings can be
removed by spraying WD-40 on them and wiping it off with a soft cloth. This may need redone several times before
all of the protective coatings are removed completely.
If any parts are missing, do not attempt to plug in the power cord and turn "ON" the machine. The
machine should only be turned "ON" after all the parts have been obtained and installed correctly.

PRODUCT SPECIFICATIONS

UNPACKING

• Round table inserts (3) (small,
medium, large)
• Open end spindle wrenches (2
• Storage hooks (2)
• Spindle tilt wheel (1)
• Spindle tilt retaining knob (1)
• Hardware package (1)
• Owner's manual (1) (not shown)
7
60 Strokes Per Minute (SPM)
1-1/2"
1725 RPM
1 HP, 110V, 10 Amps
24 – 5/8" X 24 – 1/2"
0° - 45°
1/4", 3/8", 1/2", 5/8", 3/4", 1", 1-1/2", 2", 3", 4"
4"
24 – 3/4" X 19 – 3/4"
374 Lbs
CONTENTS OF
HARDWARE PACKAGE
• 3mm Hex Wrench (1)
• 4mm Hex Wrench (1)
• 6mm Hex Wrench (1)
• 12mm Open Wrench (1)