Friedrich PTAC Manual De Instalación Y Funcionamiento página 17

CAUTION
Unit Damage Hazard
Failure to follow this caution may result in equipment damage
or improper operation.
Failure to remove shipping tape and screw will prevent fresh
air vent door from opening and may result in damage to vent
door cable.
3.. Carefully.remove.shipping.tape.from.the.front.panel.and.vent.door.. .
See.Figure.20
Figure 20
Shipping Tape Location
SHIPPING
TAPE
4. Remove.shipping.screw.from.the.vent.door,.if.present..See.Fig.21..
Figure 21
Shipping Screw Location
5.. Remove.front.panel..See.Figure.22.
Figure 22
Removing Front Panel
FRP020
Pull.out.at.the.bottom.to.release.it.from.the.tabs.(1)...Then.lift.up.(2).
NOTE:.
1
If.the.unit.is.mounted.flush.to.the.floor,.the.service.cord.MUST.
be.rerouted.at.the.bottom.of.the.front.cover.on.the.side.closest.
to.the.receptacle...A.notch.MUST.be.made.in.the.front.cover.
side.where.the.cord.exits.the.unit...It.is.the.responsibility.of.
the.installer.to.create.an.exit.notch..
REMOVE SHIPPING
SCREW IF PRESENT
FRP021
2
FRP022
17