System.configuration - Friedrich PTAC Manual De Instalación Y Funcionamiento

System Configuration
Fresh Air Vent Control
The.vent.control.lever.is.located.on.the.left.side.of.the.unit,.behind.the.
front.panel.
NOTE:.
The. vent. door. shipping. hardware. must. be. removed. before.
using.the.vent.control.lever...See.page.17,.Figure.21,.(Remove.
Shipping.Screw.from.Vent.Door.if.present).
When.vent.door.is.set.to.CLOSE,.only.the.air.inside.the.room.is.circulated.
and.filtered,.See.Figure.28.
When.vent.door.is.set.to.OPEN,.some.outdoor.air.will.be.drawn.into.room.
This.may.reduce.heating.or.cooling.efficiency.
Adjusting Air
To.adjust.air.direction:
1. Remove.front.panel..See.Figure.22.
2. Remove.louver.screws.that.hold.louver.insert.in.place.(from.back.
side.of.front.panel)..See.Figure.29.
3. Turn.louver.insert.and.rotate.180°..See.Figure.30.
4. Replace.louver.insert.
5. Replace.screws.and.front.panel.
Figure 30
Adjusting Louvers
AIR DISCHARGE OUTWARD (Default)
22
Figure 28
Air Vent Control Location
VENT CONTROL
(Pull lever through
label to operate)
Figure 29
Backside of Front Panel
LOUVER SCREWS
AIR DISCHARGE UPWARD
FRP025
FRP026
FRP027