Peaq PDR100 Manual De Instrucciones página 31

The product shall not be exposed to
dripping or splashing and no objects filled
with liquids, such as vases, shall be placed
on the product.
Care should be taken so that no objects
or liquids enter the enclosure through
openings.
No naked flame sources, such as lighted
candles, should be placed on the product.
Refer all servicing to authorised service
agent. Do not attempt to repair the
product yourself. Servicing is required
when the product has been damaged
in any way, such as the supply cord or
plug are damaged, liquid has been spilled,
objects have fallen into the product, the
enclosure is damaged, the product has
been exposed to rain or moisture, does
not operate normally, or has been dropped.
Before connecting the product to a socket
outlet, make sure the voltage indicated
on the product corresponds to your local
mains.
If the supply cord is damaged, it must be
replaced by the manufacturer or its service
agent or similarly qualified person in order
to avoid hazard.
Regularly check if the supply cord, product
or extension cable is defective. If found
defective, do not put the product into
operation. Immediately pull the plug.
Place the supply cord and, if necessary, an
appropriate extension cable in such away
that pulling or tripping over it is impossible.
Do not allow the supply cord to hang down
within easy reach.
Do not jam, bend or pull the supply cord
over sharp edges.
Only use the provided adaptor.
The adaptor power plug is used as the
disconnect device; the disconnect device
shall remain readily operable. To completely
disconnect the power input, disconnect the
adaptor power plug.
PDR100_IM_03.indb 31
The product may not function properly or
not react to the operation of any control
due to electrostatic discharge. Switch off
and disconnect the appliance; reconnect
after a few seconds.
Protect the supply cord from being walked
on or pinched particularly at the plug,
convenience receptacles and the point
where it exits from the product.
Never pull the adaptor power plug by the
supply cord or with wet hands.
Disconnect the adaptor power plug in
case of faults during use, during lightening
storms, before cleaning and when not using
the product for a longer period of time.
Danger! Before cleaning, switch the
product off and disconnect the adaptor
power plug from the socket.
When the product has reached the end
of its service life, make it defective by
disconnecting the adaptor power plug
from the socket and cutting the cord in two.
ENGLISH
31
9/27/12 6:07 PM