Changing The Display Brightness; Setting The Clock; Turning Off The Power Automatically; Sleep Timer - JVC UX-P400 Serie Manual De Instrucciones

Changing the Display Brightness

You can dim the display window.
DIMMER
DIM 1
DIM 1
Dims the display.
DIM 2
Erases the display illumination.

Setting the Clock

Without setting the built-in clock, you cannot use Daily/
Recording Timers (see page 19) and Sleep Timer.
• To exit from the clock setting, press CLOCK/TIMER as
required.
• To go back to the previous step, press CANCEL.
1
Activate the clock setting mode.
CLOCK/
TIMER
• If you have already adjusted the clock before, press the
button repeatedly until the clock setting mode is
selected.
2
Adjust the hour.
3
Adjust the minute.
Now the built-in clock starts working.
To check the current time during play
DISPLAY
Source information
Remote
ONLY
DIM 2
DIM OFF
(Canceled)
Remote
ONLY
SET
SET
Clock
Turning Off the Power
Remote
Automatically
ONLY
To turn off the unit after playback is over—Auto
Standby
A.STANDBY
When Auto Standby is in use, the A.STANDBY indicator
lights on the display.
When the tape or disc play stops, the A.STANDBY indicator
starts flashing. If no operation is done for about 3 minutes
while the indicator is flashing, the System turns off (stands
by) automatically.
• Auto Standby does not work while you are listening to
radio and the external component (AUX).
To turn off the unit after a certain period of time

—Sleep Timer

1
Specify the time (in minutes).
SLEEP
10 20 30
2
Wait until the set time goes off.
To check the time remaining until the shut-off time
SLEEP
• If you press the button repeatedly, you can change the shut-
off time.
ON OFF
(Canceled)
60 90 120 150
Canceled
SLEEP
13