Getting Started; Supplied Accessories; Putting The Batteries Into The Remote Control; Connecting Antennas - JVC UX-P30 Manual De Instrucciones

Getting Started

Supplied Accessories

Make sure that you have all the following items.
The number in the parentheses indicates the quantity of each
piece supplied.
• AM loop antenna (1)
• FM antenna (1)
• Remote control (1)
• Batteries (2)
• AC plug adaptor (1)
If anything is missing, consult your dealer immediately.

Putting the Batteries into the Remote Control

Insert the batteries—R6(SUM-3)/AA(15F)—into the remote
control, by matching the polarity (+ and –) on the batteries
with the + and – markings on the battery compartment.
When the remote control can no longer operate the unit,
replace both batteries at the same time.
1
2
3
• DO NOT use an old battery together with a new
one.
• DO NOT use different types of batteries together.
• DO NOT expose batteries to heat or flame.
• DO NOT leave the batteries in the battery
compartment when you are not going to use the
remote control for an extended period of time.
Otherwise, it will be damaged from battery
leakage.

Connecting Antennas

FM antenna
1
2
3
The FM antenna supplied with this unit can be used as temporary
measure. If reception is poor, you can connect an outdoor FM
antenna.
R6(SUM-3)/AA(15F)
To connect an outdoor FM antenna
Before connecting it, disconnect the supplied FM antenna.
Attach the FM antenna to the FM 75 Ω
COAXIAL terminal.
Extend the FM antenna.
Fasten it up in the position which gives you
the best reception, then fix it on the wall, etc.
About the supplied FM antenna
Outdoor FM antenna
(not supplied)
Coaxial cable
A 75 Ω antenna with coaxial type connector (IEC
or DIN 45325) should be used.
Continued
FM antenna (supplied)
6