Intended Use - Pontec PondoSolar 600 Control Instrucciones De Uso

- EN -

Intended use

PondoSolar 600 Control, referred to as "unit", may only be used as specified in the following:
· For creating a water fountain in a pond.
· For operation with clean water.
· Operate in accordance with instructions.
The following restrictions apply to the unit:
· Never use the unit with fluids other than water.
· Never run the unit without water.
· Do not use in conjunction with chemicals, foodstuff, easily flammable or explosive substances.
Installation and connection
How to proceed:
5 B
1. Assemble the nozzle unit and the LED lighting and fit onto the pump.
– Adapt the number of nozzle extensions used to the depth of the pond.
2. Connect the connection cables of the pump and LED lighting to the solar module. (→ Commissioning/start-up)
– Push each plug into the socket as far as possible to ensure that the connection is watertight.
3. Assemble the ground stake set and attach it to the solar module.
– Align the solar module such that the sockets with the connection cables point downwards.
4. Install the solar module so that it is exposed to direct sunlight.
– Recommendation: Align the solar module to the sun to ensure maximum energy yield.
5. Install the unit in the pond in a horizontal position on firm, sludge-free ground and ensure that it is completely cov-
ered with water.
10