Technical Data; Layout And Items Supplied; Proper Use - EINHELL DSL 250/2 Manual De Instrucciones

from e.g. cutting, grazing and high tempe-
rature. Wear suitable gloves to protect your
hands.
•
Hold the machine correctly: Be prepared to
cope with expected or sudden movements —
keep both hands ready.
•
If there is a power failure, release the com-
mand device for starting and stopping.
There is a risk of electrostatic discharge when
the machine is used on plastic and other non-
conductive materials.
•
A potentially explosive atmosphere can arise
from the dust and vapors caused by grinding
and sanding. A suitable dust extraction sys-
tem must be used where necessary.
•
Disconnect the grinding/sanding machine
from the power supply before replacing the
mounted tool or accessory parts.
•
During and after use, avoid contact with the
mounted tool because it may have become
hot or sharp.
•
Only grinding/sanding attachments recom-
mended by the manufacturer are allowed to
be used.
•
It is imperative to observe the accident pre-
vention regulations in force in your area as
well as all other generally recognized rules of
safety.
•
Take suitable precautions to reduce the resi-
dual risks, e.g. injury to the user due to noise,
vibrations, dust, etc. This can mean for ex-
ample: Wear ear plugs and safety equipment,
use a vacuum dust extractor.

2. Layout and items supplied

2.1 Layout (Fig. 1)
1. trigger lever
2. connector
3. adapter sleeve mount
4. adapter sleeve + lock nut
5. plug-in nipple for the air supply

3. Proper use

The pin grinder is a handy pneumatic tool for use
in DIY and automotive workshops.
The exhaust air leaves the tool through the outlet
to the rear. The air supply is connected to the tool
by means of a quick-release coupling.
The equipment is to be used only for its prescri-
GB
bed purpose. Any other use is deemed to be a
case of misuse. The user / operator and not the
manufacturer will be liable for any damage or inju-
ries of any kind caused as a result of this.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
Repairs and maintenance work are to be carried
out only by authorized specialist workshops.
Please note!
The power of the tool will be reduced if you
use a hose that has too small an inner diame-
ter or which is too long.

4. Technical data

Permissible working pressure max.: ......... 6.3 bar
Idle speed: .......................................22,000 min
Air consumption (6.3 bar): ..................128.3 l/min
Recommended hose diameter: .............Ø 10 mm
Weight: .....................................................0.65 kg
Danger!
Sound and vibration
Sound and vibration values were measured in
accordance with EN 792-9.
L sound pressure level ..................... 93.8 dB(A)
pA
K uncertainty ............................................. 3 dB
pA
L sound power level ....................... 83.5 dB(A)
WA
K uncertainty ............................................. 3 dB
WA
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 792-9.
Vibration emission value a
K uncertainty = 1.5 m/s
The specifi ed vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equip-
ment is used and may exceed the specifi ed value
in exceptional circumstances.
- 13 -
= 2,5 m/s
2
h
2
-1