Installing The Refrigerator - GE 26 Manual Del Propietario Y Instalación

Installation Instructions
INSTALLING THE REFRIGERATOR
REFRIGERATOR LOCATION
• Do not install the refrigerator where the temperature will
go below 60°F(16°C) b ecause it will not run often enough
to maintain proper temperatures.
• Do not install the refrigerator where the temperature will
go above 100°F(37°C)because it will not perform properlU.
• Install it on a floor strong enough to support it fullUloaded.
CLEARANCES
Allow the following clearances for ease of installation, proper
air circulation and plumbing and electrical connections.
Sides 1/8" (3 mm)
Top 1" (25 ram)
Back 1" (25 mm)
[] REMOVE THE FRESH FOOD
DOOR HANDLE
Stainless steel and plastic handles:
REMOVING THE DOOR
HANDLE: Loosen
the set screws
with the 1/8"
Allen wrench
and remove
the handle.
NOTE: If the handle
mounting fasteners
need to be tightened
or removed, use
a Phillips-head Hounting/
screwd river.
Fasteners
1
J
REMOVINGTHE REFRIGERATOR D OORS
• IMPORTANT NOTE:This refrigerator is 35.6" deep. Doors
and passagewags leading to the installation location
must be at least 36" wide in order to leave the doors and
handles attached to the refrigerator while transporting it
into the installation location. If passagewags are less than
36", the refrigerator doors and handles can easilg be
scratched and damaged. The top cap and doors can be
removed to allow the refrigerator to be safelg moved
indoors. Start with Step 1.
• If it is not necessarg to remove doors, skip to Step 9. Leave
tape and all packaging on doors until the refrigerator is in
the final location.
• NOTE:Use a padded hand truck to move this refrigerator.
Placethe refrigerator on the hand truck with a side
against the truck. We stronglg recommend that TWO
PEOPLE move and complete this installation.
[] REMOVE THE FREEZER DOOR HANDLE
Stainless steel and plastic handles:
@ Loosen the set screws located on the underside
of the handle with the 1/8" Allen wrench and
remove the handle.
NOTE: If the handle mounting fasteners need
to be tightened or removed, use a Phillips-head
screwdriver.
16