Cleaning And Caring For The Inverter; Rectifying Faults - Dometic WAECO SinePower Serie Instrucciones De Montaje

Cleaning and caring for the inverter

Charging the device via the USB port
NOTE
I
Also observe the operating manual of the device you want to
charge via the USB port.
➤ Connect the device to the USB port (fig. 1 4, page 3) of the inverter.
9 Cleaning and caring for the inverter
NOTICE!
A
Do not use any sharp or hard objects for cleaning since they may
damage the device.
➤ Occasionally clean the device with a damp cloth.
10

Rectifying faults

NOTE
I
If you have detailed questions on the specifications of the
inverter please contact the manufacturer.
Fault
No output voltage, no LED
lights up
No output voltage, green
and red LED light, warning
sound, power consuming
device is swichted off
26
Cause
No contact to the battery
Defective fuse (in the inverter
or the vehicle)
The battery voltage is less than
11 V (MSI212/MSI412) or 22 V
(MSI224/MSI424)
Poor contact to the battery
Input voltage too high.
SinePower
Remedy
Check contact and cable.
Have an electrician change
the fuse.
Charge the battery (start the
engine).
Clean the contacts.
Check the input voltage.
reduce the input voltage.
EN