Cleaning And Caring For The Inverter; Troubleshooting - Dometic WAECO SinePower MSI 924M Instrucciones De Montaje Y De Uso

Cleaning and caring for the inverter

11 Cleaning and caring for the inverter
A
NOTICE!
Do not use sharp or hard objects or cleaning agents for cleaning
as these may damage the product.
➤ Occasionally clean the product with a damp cloth.
12

Troubleshooting

!
WARNING!
Do not open the device. You risk sustaining an electric shock by
doing this.
I
NOTE
If you have detailed questions on the specifications of the
inverter please contact the manufacturer (addresses on the back
of the instruction manual).
The "Load Status" LED (fig. 5 3, page 4) lights up red to indicate the fault:
LED display
Quick flash
Slow flash
Occasional flash
46
Cause
Input voltage is too high
Input voltage too low
Overheating
Remedy
Check the input voltage and reduce
it.
The battery needs recharging.
Check the cables and connections.
Switch off the inverter and the con-
sumer.
Wait 5 to 10 minutes and switch the
inverter on again without any electric
consumers.
Reduce the load and make sure the
inverter has better ventilation. Then
switch the consumer back on.
MSI924M
EN