Analogue/Digital Tv: Measuring The Carrier / Noise Ratio (C/N) - Promax TV EXPLORER HD ATSC Manual De Instrucciones

The instrument also demodule the FM carrier (radio) and allows to listen sound
through the loudspeaker [33].

5.14.5 Analogue/Digital TV: Measuring the Carrier / Noise ratio (C/N).

The TV EXPLORER
ways, according to the carrier type and the used band:
A) Terrestrial band, analogue carrier
Carrier level is measured using a quasi-peak detector (230 kHz BW). Noise level is
measured with an average detector and corrected to refer it to channel equivalent
noise bandwidth (according to the definition of the selected standard).
B) Terrestrial band, digital carrier
Both measurements are done with an average detector (230 kHz) and the same
corrections are introduced on them (bandwidth corrections).
C) Satellite band, analogue carrier
Carrier level is measured using a quasi-peak detector (4 MHz BW). Noise level is
measured with an average detector (230 kHz) and corrected to refer it to channel
bandwidth.
D) Satellite band, digital carrier
Equivalent to case B but now using the 4 MHz BW filter.
Page 52
Figure 27.- FM analogue signal measurement.
HD ATSC carries out C/N ratio measurement in four different
USER'S MANUAL. TV EXPLORER HD ATSC
12/2010