Setting The Ts-Asi Input-Output - Promax TV EXPLORER HD ATSC Manual De Instrucciones

USER'S MANUAL. TV EXPLORER
5.20

Setting the TS-ASI Input-Output

The TS-ASI option is a key feature for a TV analyser. It allows both input and
output transport streams. It automatically detects whether the stream is composed of
188 or 204 bytes. It can transmit in packet mode or burst mode.
To configure the TS-ASI inputs and outputs, access from the TV mode or from the
measurement mode.
From the TV mode, press the measurement configuration
SETUP menu and go to the bottom of the menu until the Enable ASI INTERFACE.
Select the option by pressing the rotary and turn it to go from OFF to ON. Press
the rotary to accept the change. There are two new options, which are:
ASI OUTPUT SOURCE
It allows you to select the output signal between two options: DEMODULATORS
and AUXILIAR. The DEMODULATORS option uses the TS coming from the
internal demodulator, which is active at that time. The AUXILIARY option uses any
video file.
TS INPUT SOURCE
It allows selecting the TS to use in the decoder. The INTERNAL option uses the
TS coming from the internal demodulator of the instrument. The EXTERNAL
option uses the TS connected through the TS-ASI input by the user.
12/2010
HD ATSC
Figure 57.-
[17] to access the
Page 79