Tv Operating Mode - Promax TV EXPLORER HD ATSC Manual De Instrucciones

You can also access the TS-ASI option from the MEASUREMENT mode. Press
the key for measurement configuration
the bottom of the menu until the option Enable ASI INTERFACE.
Select the option by pressing the rotary and turn it to switch from OFF to ON.
Press the rotary to accept the change. Now there is a new option:
ASI OUTPUT SOURCE option as explained above, allows selecting the output
between two options: DEMODULATORS and AUXILIAR. The option DEMODULATORS
uses the TS that comes from the internal demodulator which is active at that time. The
AUXILIARY option uses any video file.
5.21

TV Operating Mode

When pressing the
HD ATSC accedes to the TV mode, and tries to demodules on the monitor the currently
video signal on tune.
In the monitor will appear the TV picture with a window on the lower part to show,
for five seconds whenever the signal is analogue; the channel number, the frequency,
the active channel set, the colour system and the TV standard.
Page 80
USER'S MANUAL. TV EXPLORER
Figure 58.-
[17] to access the SETUP menu and go to
[10] key from any mode of operation the TV EXPLORER
HD ATSC
12/2010