Bosch Nexxt 500 Plus Serie Manual De Instrucciones página 9

Water drainage
Do not bend or pull the water
drainage hose.
Height difference between the
installation location of the washing
machine and the drainage point:
Maximum 8 feet / 244 cm,
minimum 2 feet / 60 cm,
Connecting the water
drainage hose
Do not remove the screw from
the clamp assembly. Loosen
the screw only enough so that the
clamp will slide freely onto the
water drain hose.
2. Attach the drain hose to the
drain hose connection on the
back of the appliance; position
the hose clamp approximately
3/8 inch (9 mm) from the end of
the hose.
3. tighten the clamp with a
screwdriver
Standpipe Installation
Use the elbow. Attach the elbow to
the end of the hose and insert end
of hose into standpipe.
Use a strap or cable tie to hold
hose in place.
In-Wall Installation
Use a strap or cable tie to hold
hose in place.
Drainage into a siphon
Secure the connection point with a
hose clip(not included in
factory supplied equipment).
Drainage into a sink
Ensure that the plug is not in the
drain hole.
1. Place the hose clamp over the
end of the drain hose before
attaching the drain hose to the
appliance.
Use the elbow. Attach the elbow to
the end of the hose and insert the
end of the hose into the wall drain.
The hose and elbow should
extend into the open drain pipe as
far as the elbow allows when
seated as shown in the above
picture.
Attach water drain hose securely
to sink.
Use a strap or cable tie to hold
hose in place.
When the water is being drained,
check that the water flow out of
the sink is adequate.