Worx WG112 Manual De Instrucciones página 6

Figu_ 2 Method of securing e:_e.sio.
cord
CORD APPLIANCE CORD
// \',
(A) tie cord as sho_
(B)
J)
co.nect p|ug and receptac|e
Avoid unintentional starting. Don't
carry plugged-in appliance with finger
on switch. Be sure switch is offwhen
plugging in.
k) Don't abuse cord. Never carry appliance
by cord or yank it to disconnect from
receptacle. Keep cord from heat, oil, and
sharp edges.
I) Don't grasp the exposed cutting blades or
cutting edges when picking up or holding
the appliance.
m) Don't force appliance. It will do the job
better and with less risk of injury at the
rate for which it was designed.
n) Don't overreach. Keep proper footing and
balance at all times.
o) Stay alert. Watch what you are doing. Use
common sense. Do not operate appliance
when you are tired.
p) Disconnect appliance. Disconnect the
appliance from the power supply when
not in use, before servicing, when
changing accessories such as blades, and
the like.
q) Store idle appliances indoors.When not in
use, appliances should be stored indoors
in dry, and high or locked-up place, out of
reach of children.
r) Maintain appliance with care. Keep
cutting edge sharp and clean for
s)
best performance and to reduce the
risk of injury. Follow instructions for
lubricating and changing accessories.
Inspect appliance cord periodically,
and if damaged, have it repaired by
an authorized service facility. Inspect
extension cords periodically and replace
if damaged. Keep handles dry, clean, and
free from oil and grease.
Check damaged parts. Before further use
of the appliance, a guard or other part that
is damaged should be carefully checked
to determine that it will operate properly
and perform its intended function. Check
for alignment of moving parts, binding
of moving parts, breakage of parts,
mounting, and any other condition that
may affect its operation. A guard or other
part that is damaged should be properly
repaired or replaced by an authorized
service center unless indicated elsewhere
in this manual.
3. EDGIPR_TR|MMERS
a) Keep guards in place and in working
order.
b) Keep blades sharp.
c) Keep hands and feet away from cutting
area.
4, CULT|VAT@IRIS, G_$S SHEARS
a) Keep hands away from blades.
Save these instructions.