Worx WG112 Manual De Instrucciones página 8

m
IO
_ NARMNG:The cutting head continues
to rotate after the trimmer has been
switched off.Wait until it stops before laying
the trimmer down.
QPERATIQN
_ ARNING: Always wear eye protection
and heavy clothing to prevent rocks and
debris from hitting you and causing an eye
injury or other serious injuries. Use two hands
operate the trimmer and hold the unit below
waist level.To best ensure that debris is thrown
away from your body, work only from the
right to left. For optimal trimming and edging
results.While maintaining comfort, keep the
trimmer head parallel to the ground when
trimming (perpendicular, when edging).When
trimming be sure to keep sufficient distance
between the cutting line and the ground.
_ WARN|NO: Use only 0.065"
(1 .GSmm) diameter cutting |inc.
Other line sizes _ii| not properly feed
in the trimmer head and couW cause
serious inju_. Newer use other materials
such as wires, string or rope, as this
may break off during cutting and cause
serious injuW.
TR|MMING
Hold the bottom of the trimmer head about
3 inches above the ground and at an angle.
Allow only
the tip of line to make contact. Do not force
trimmer line into work area.
EDG|NG (See H)
Unscrew the upper adjustment knob (3),
rotate the main and auxiliary handle 90°, and
retighten the knob. Adjust trimmer head angle
so that it is in line with the shaft (horizontal).
Put the wheel on the ground to begin edging,
using the white line guides to indicate the
cutting position at the edge of your lawn.
While edging, allow the tip of the line to make
contact. Do not force the line.The wheel helps
prevent the unit from touching the ground.
Take extra caution while edging as objects can
be thrown from the trimmer line.
AUTOMATIC LiNE FEED SYSTEM
When initially switching on the trimmer, a
small length of line is fed out. A 'clattering'
noise will be heard for a short time.This
is normal and is caused by the line being
cut bythe line cutter. Once the line is cutto
the correct length, the 'clattering' noise will
stop and the trimmer motor will run at full
speed.To feed more line, stop the trimmer
completely, then restart, allowing the motor
to reach full speed. Repeat this until you hear
the 'clattering' noise of the line cutting. (Do not
repeat this procedure more than 6 times)
REMOVING THE CAP TO MANUALLY
FEED THE LiNE (See |)
Press and release manual line feed button
(16), whilst gently pull out the lines until
the lines reaches the line cutter. When the
required amount of line is fed out, gently pull
on the second line (there is no need to press
the manual line feed button again). Ifthe line
extends past the line cutter, too much line
has been fed out. Iftoo much line is fed out,
remove the spool cap and click the spool anti-
clockwise until the line is at the desired length.
REMOVING THE CAP
Press and hold in the two latches (12)(See
J).Pull cap away from the spool holder. Keep
the cap and spool holder clean from debris.
To replace the cap, press it firmly towards
the spool holder. Ensure that it is correctly
connected by trying to remove it without
depressing the two latches.
CHANGING THE LiNE SPOOL:
First take off the cap and remove the old spool.
Place new spool into cutting head. Feed one
line through the eyelet, then repeat for second
line. Reattach the cap.