Connecting Aerweb300; Electric Power Supply; Installing Aerweb300 - AERMEC AERWEB300 Manual De Instalación

!

Connecting AERWEB300

Electric power supply

Installing AERWEB300

WARNING:
During the initial step, further to the start up, some leds may blink till this phase comes to an end
This is normal and indicates the start-up phase is regularly getting on
ATTENTION: Remember that the device is prevented from being switched on accidentally by
providing the power supply only after having completed all the connections. Moreover, a Personal
Computer (Desktop/Notebook/Netbook) is absolutely necessary.
AERWEB300 is seen in the picture at the side; a
detailed explanation regarding each connection is
found below. A few examples are found at the end of
this chapter.
AERWEB300 must be powered directly with an AC
voltage range of 90 - 265 Vac, 50-60 Hz, through Pin 1
and 2 of the "Power Supply" terminal board, by means
of the removable connection supplied.
Power supply terminal =
5154650_03
21
GB