Setting The Timer Manually - Waring Commercial WDM120 Manual De Instrucciones

The drink mixer can be operated without engaging the ON/OFF
cup actuator by using the PULSE
switch will operate at whatever speed the 3-speed switch is set to.
The PULSE
backward. Keep a firm grip on the cup while using PULSE
Your Waring
®
1 standard and 1 "butterfly" (with the movable flaps), per spindle.
To switch agitators, simply hold the spindle shaft with one hand
and turn the agitator in a clockwise direction. This will loosen
the screw, and you can unscrew to remove. Insert replacement
agitator and screw bottom screw back in. Tighten by turning the
agitator in a counterclockwise direction. Use only a standard
metal mixing cup with the standard agitator.
TIMER UNIT INSTRUCTIONS
To operate your drink mixer with the
timer, you must follow the following
instructions:
1. When plugging in the unit, the timer(s) will automatically read
R0:00.
2. NOTE: To turn the timer off at any point, press the
three times in rapid fashion. To turn the unit back on, tap the
or arrow once and the unit will display R0:00, or any
previously set time.
3. You can reset your time at any point by pressing and holding
the and
4. There are two ways to set the timer for your commercial
drink mixer:

Setting the timer manually:

1) Press and hold the
will enter into time-setting mode S0:00.
2) Once the timer is on and you have activated setting
mode, you can set the timer using the
(HINT: holding the arrow buttons down will allow you to
count up in 10-second increments.) Unit will display S
(time selected).
3) When you've reached your desired time, the timer will
automatically set after 3 seconds.
switch will operate only while pressed forward or
Commercial Drink Mixer is supplied with 2 agitators,
arrows simultaneously for 3 seconds.
toggle switch. The PULSE
arrow for 3 seconds and the unit
4
arrow
and arrows.
.