Waring Commercial WDM120 Manual De Instrucciones página 6

The drink mixer can be operated without engaging the ON/OFF
cup actuator by using the PULSE
The PULSE
switch is set. The PULSE
pressed forward or backwards. Keep a firm grip on the mixing
cup while using PULSE
CLEANING & MAINTENANCE INSTRUCTIONS
1. Rinse cup thoroughly under running water. Add 8 ounces of
clean water to the cup. Place cup in the normal operating
position on the mixer and run on HI (III) speed for two (2)
minutes. Empty cup.
2. UNPLUG MIXER POWER CORD FROM ELECTRICAL
OUTLET.
3. To remove the bottom cup supports (C), simply push each
support up then pull out towards you.
4. To remove the upper cup supports (D), firmly hold the
notches on both sides of the support, then pull directly out
from the base.
5. Wash, rinse and sanitize the upper and bottom supports and
cup. Sanitize these parts by immersing in sanitizing solution
for two (2) minutes. Shake excess moisture off and allow all
parts to air-dry.
6. Working from the top down, wash, rinse, and sanitize the
portion of the mixer housing situated directly over the mixing
cup and the portion of the spindle above the agitator using
absorbent wiping cloths moistened with cleaning solution,
rinse water and sanitizing solution.
7. Reassemble ON/OFF switch actuator and mixing cup
supports to mixer housing by reversing steps 3 and 4.
8. For each spindle, wash, rinse and sanitize the bottom of the
switch will operate at whatever speed the 3-speed
toggle switch.
switch will operate only while
6